How to Design Schematic Circuit of Metal detector.

You can use this simple metal detector to locate plumbing pipes, electrical wiring inside walls, find a lost watch or coin at the beach or even a treasure with gold coins buried years ago by pirates.

You can also use the circuit in experiments where you can show the magnetic properties of materials. The differences between paramagnetic, diamagnetic, and nonmagnetic materials can be shown. Interesting experiments can be conducted using the metal detector described here.

This circuit will detect the presence of metallic objects through any nonconductive material such as dirt, wood, stone, plaster or plastic. With a little practice, you will be able to detect metallic objects to depths of over several inches and will give you a fairly good idea of their size. Our circuit uses the beat-frequency method to detect an object.

The frequency of the search coil oscillator changes when the conductance in the field of the search coil changes. Therefore, when metals come within a short distance of the coil, the frequency is changed, which in turn changes the pitch of the audible sound.

The sound is produced by the speaker of a common AM receiver that tunes the coil oscillator.

A schematic diagram of the Metal Detector is shown in circuit. Observe that the circuit is a very simple one-transistor oscillator. You can also use a general-purpose PNP silicon transistor, inverting the power supply polarity.

The physical arrangement of the electronic components, using a terminal strip as chassis, is shown in circuit. The critical part of this project is the search coil.

The search coil is wound in a large 6-inch plastic Frisbee. Begin by securing one end of the enameled magnet wire form (18 to 22 AWG) with masking tape. On the tenth wrap (halfway) form a loop in the magnet wire for the center tap, then continue until you complete the 20 turns of wire.

It is very important to secure the coil wire firmly, as one loose loop in the coil will cause the detector to be unstable.

To use:

Fix a small portable radio close to the oscillator as shown in circuit.

Tune the radio to a free point of the range between 550 and 1,600 kHz. Adjust

CV in the search coil oscillator to tune this signal as a whistle. If you can't find the oscillator signal in the AM band, reduce or enlarge the search coil by a few turns.

Passing the search coil over a metallic object will change the pitch of the whistle. When the most pronounced change occurs, you should be directly over the metal object.

Parts List - Metal Detector

Q1 - 8C548 general-purpose NPN silicon transistor

Ll - Search coil - see text

CV - 365 pF - any variable capacitor (from nonworking AM radio)

C1 - 2,200 pF ceramic capacitor

C2 - 0.1uF ceramic capacitor

Rl - 10,000 ohm, 114W,5% resistor

51 - SPST slide or toggle switch

B1 - 6 or 9V - four AA cells or 9V battery